Recent content by TAPH2O

They did’nt have the specific mold for my daughters 36c

My daughter has one without teak decking. I think there are at least three here in the Portland area. no teak decking though.

What does a 36 cruising look like?

Same thought of why the off center was it to counter act the prop walk or make so one could get the prop shaft out?

Can you throw the compression release on with the engine running to tell if it has an effect without damaging the engine?

Got it made but engine won’t let us get it up to speed with the compression release engaged it goes for half a revolution then is to difficult to turn any further.

Job done thanks for the help now to see if it works

Here is another way of doing it. http://boatbummsparadise.blogspot.com/ search the refit vids

On my daughters 36c the screws are ornamental and it is 1/4” glued down and it is delaminating. The ugly spot beside the hole is where I chiseled the 1/4” up now left with replacing the whole faux sole and maybe cutting the plastic out from underneath to gain access to hoses and wiring and get...

Did you cut those holes?

Looks about right. im looking into having a socket welded on to straight stock that would accept winch handle star drive that would allow me to use my Milwaukee 1/2” right angle 24volt drill with winch attachment.

I will ask my daughter about the engine it’s her boat but you can never have enough boat engines. another question a[bout some of the lengths of the straights and how is the sleeve held on. many thanks taph2o

The valves are by the mast but other than that no access. It is 1/4” fake teak and holly glued down and fake little screws for looks. Teak and holly 1/4” sheet of waterproof not marine grade plywood is $280 Here in Portland. Marine grade in tacoma is in the mid $300’s.

thanks. Papillon has a lafielle mast iwith a slot mainsail track and i believe a four shive head with the halyards led externally and run fore and aft ver the top. So you only get 2 halyards. Please take picks of your fiddle block arrangement for the main boom topping lift. There is no place...

Im looking for one. And or thorough measurements of one.