trickdhat's latest activity

Thanks for the faucet recommendation Loren. My faucet is a wide set 2 hole mount. I'm trying to find one that covers the wide holes or...

I designed it, purchased the material, and had a local fabrication shop build it. It was difficult to tell what the original material...

I don't imagine the 35-2 is exactly like the 25+, but they both have a wooden block in the bilge supporting the compression post...

We always did it in the water. It wasn't a deliberate choice, just where the boat was most of the time. I know you probably want to...

The mast on my 1980 25+ had a pivoting mast step that allowed the mast to be lowered forward. It came with guy wires to go between the...

I'm thinking it's a combination of a blocked kitchen faucet and an oversize pump. The pump runs continuously if I have adequate flow...

Perko is crazy expensive and the quality isn't anywhere close to justifying it. I found the hardware on Amazon. It's about the same...

A Win!! It wasn't easy or pretty, but I'm excited to have this one checked off the list. I had to carefully cut the latch housing with...

Eknebel, The boat is new to me and I didn't operate the old pump in all the configurations. It leaked so bad I didn't want to leave it...

I got down to the boat yesterday to troubleshoot the system. To eliminate the vent as an issue, I opened both deck fills, turned on the...

I probably should have referenced the thread I found the advice on the knob...

I wasn't able to make it down to the boat last night, but I was racking my brain trying to figure out what could be causing this...

What started off with a simple idea of removing the head door to trim the top has evolved into a complete overhaul. The hinge won’t...

I'm confused (that's a common state of mind for me). I thought you said you had extreme pulsing at the galley faucet. Was that before...

Do you have low flow from the galley faucet too?