O34 Mast Wedges & Gaiter, (Kenyon O-34)

Back a couple decades ago, I replaced the factory hardwood wedges. They had put in four, with longer ones on each side. There were "corner" areas with no wedging/support, and it seemed like there should be more continuous support all the way around. I made these out of teak scrap and they are still in fine condition, so were reused.
Each one is L shaped so there is a 'shoulder' on top to keep it from dropping thru. As before, I put a layer of sealant around the top of them so they do not...
You do not have permission to view the full content of this entry. Log in or register now.
  • Mast Wedges O-34.jpg
    Mast Wedges O-34.jpg
    170.5 KB · Views: 474
  • Wedges in place.jpg
    Wedges in place.jpg
    155.8 KB · Views: 42
  • Mast boot Gaiter.jpg
    Mast boot Gaiter.jpg
    76.5 KB · Views: 37
  • Vinyl Boot Starb..jpg
    Vinyl Boot Starb..jpg
    155.4 KB · Views: 29
  • Vinyl Boot Port.jpg
    Vinyl Boot Port.jpg
    166.1 KB · Views: 29

Blog entry information

Author
Loren Beach
Views
136
Last update

More entries in Rigging & Sail Controls and Assoc. Deck Hdwe

More entries from Loren Beach

Top