floor

Hello All, Considering a new inflatable dinghy with a high pressure air floor for a few reasons. I don't like towing a dink, slows the boat and puts the dink at risk. Hard dinks are great but heavy and again I don't want to tow. Forget davits, I can't ugly up my boat like that. My...

Has anyone tried anything like these for their cockpit floor? http://cgi.ebay.com/Le-click-Teak-Interlocking-Snapping-Deck-Tiles-Box-10EA-/130494106525?pt=Tile_Flooring&var=&hash=item641f07c93c Just wondering if this might work. I had taken the old rubber mats 12" x 12" tiles out, as they...

Our floor is in.-photo's added Had to remove the hood on the top of the sliding hatch to get the rear section in the boat, the photo shows the floor down and screwed in with stainless hardware. We got the bilge clean and everything organized. The finish will go on in the next week. Memorial Day...

I have noticed that the teak and holly flooring on my E-28 could use a little "sprucing up" (no pun intended). It's not bad, just showing a little wear. Also it seems the softness of the teak has allowed a little bit of sand to get embedded into it in places or could I have not noticed before...

Here's the progress on the new cockpit floor. After removal of a peat-bog like substance - 30 year old MUD! A large hole in the inner skin was revealed. I Taped a peice of foamcore (real estate sign) to the underside and started with a 3 of layers of cloth - then added 1/2 inch balsa (wetted...

I'm looking to replace the teak and holly sole in my 88 Ericson 38-200. It's worn in some places, esp at the seams, there's some water damage near the mast and in the galley from the dogs water dish, and some general dings and stuff. So, thinking that I'd rather be using my vacation time for...

Hi, all- Shower stall leaks that were finally corrected this summer have resulted in a soft, delaminating teak and holly sole in the head of our 35-3. The damaged area extends to just inside the head door and the edge of the shower sump. I need to remove the damaged flooring and replace with...

Good Afternoon, This weekend I noticed that my cockpit floor was a bit "bouncy." I would not describe it as soft but there is a bit of movement. The offending area is to the starboard side of the pedestal. It is not a large area, maybe a foot square. I drilled a few holes in the underside of...

Hi: I just purchased a 1988 Ericson 38-200 and love the boat. I have found that the Teak and Holly Sole creaks underway. I suspect a couple of things: 1. The screws below the bungs need to be tightened 2. The solid teak trim around the fall flexes against the teak furniture modules Has...

I am replacing the cabinets in the head of my 35-2, and, upon removal of old cabinets, noticed that the drain pan in the floor of the head does not lay flush against the hull...there is a running gap of 1.5in forward down to about .5 in aft. Is this gap there by design, or can I close fill the...

This Future floor treatment is great stuff and it works really well! I got the tip from Guy’s post here: http://www.ericsonyachts.org/infoexchange/showthread.php?t=2488 Not wanting to hijack the thread, I decided to start a new one :) Got it from the local grocery store. I used...

I have a soft spot in the floor between the satrboard sette and the table on my E35-III. I have replaced the supports for the removable floor sections. They were "held"in by SS screws which extended no more than a quarter of an inch into the plywood subfloor. That stiffened the overall floor...