Latest activity
-
BCompass Marine's Bed-It tape is available for pre-order (Rod posted the link on FB). Shipping in late August: Bed-It Tape
-
Prairie Schooner replied to the thread Harken Mark 1 Feeder.Ours is a Harken Unit 1 so it should be the same. It's always good to have at least one spare screw to drop in the water or bilge. I'll... -
Uunidiver replied to the thread Harken Mark 1 Feeder.Two screws and it’s off. Could use the screws as spares. Photo of mine attached. Thanks!
-
-
grarya01 reacted to ThurstonCounty's post in the thread Looking for an E27, E28, or E29. Have advice or a boat? (PNW, Wanted, WTB) with
Like.
Welcome my brother! We did the same thing, yearn for 20-years and finally get the position that we can get one. We picked up a E29 on... -
ThurstonCounty replied to the thread Looking for an E27, E28, or E29. Have advice or a boat? (PNW, Wanted, WTB).Welcome my brother! We did the same thing, yearn for 20-years and finally get the position that we can get one. We picked up a E29 on... -
Prairie Schooner replied to the thread Harken Mark 1 Feeder.We just got a new furler and the old one is still laying at the marina. Our boats are the same model and year so it should be the same...
-
patrscoe replied to the thread 1988 Ericson 34-200 for Sale, Apostle Islands, WI.Joe & Kathy, Did you move the traveler to the cockpit? If so, did you like it more or less than when it was on the cabin top? -
UOne of the "C pins" that holds the clamshell feeder on my furling system has broken off and I don't have the knowledge or equipment to...
-
-
Rusty/muddied coolant water is another candidate. -
Slick470 replied to the thread New Mast/Standing Rigging and Olson History.A number of the Olson 911s have upgraded rudders too. From what I understand the original rudder wasn't quite deep enough to maintain... -
Compass Marine's Bed-It tape is available for pre-order (Rod posted the link on FB). Shipping in late August: Bed-It Tape
-
Charlie B. replied to the thread New Mast/Standing Rigging and Olson History.Sounds like you are making major progress! That area set aside for the mast assembly looks like a sweatshop. Regarding the rudder... -
Christian Williams replied to the thread Scenario Planning: Hulled.The compartments all have limber holes and drain to bilge. -
toddster replied to the thread Scenario Planning: Hulled.Don't the bulkheads under the v-berth rise above the water line? A bit anyway. Until you start penetrating them with vents, drawers... -
goldenstate replied to the thread Redish Water in Bilge.Rusty/muddied coolant water is another candidate.
