• Untitled Document

    The 2024-2025 Fund Raising Season has Opened!

    EricsonYachts.org has opened the season for raising funds to support the expenses of the site. If you would like to participate, please see the link below for additional information.

    Thanks so much for your continued support of EricsonYachts.org!

    2024-2025 Fund Raising Info

nav

  1. bigd14

    Nav Light on Bow Pulpit Question

    I am relocating the bow lights to the pulpit and am wondering about how to seal the holes I will have to drill (or, figure out a way to make sure it all drains out somehow). The wires will enter at the top and exit on the aft stanchion base on the port side. If any water gets in it will travel...
  2. toddbrsd

    Nav Pod on the Cheap

    I was looking for a pedestal guard, mainly to mount my handheld gps and maybe a pocket for my handheld vhf. Based on the price, and limited space on the E27 due to the main sheet location, I made a smaller "Nav Pod" I don't intend on doing a lot of cruising, very far from Port, so this should...
  3. R

    Converting ABI Nav Light from Zenon to LED

    Hello All, I thought I'd share this with you how to convert a 7 inch ABI Nav Dome Light from Zenon to LED. I did this just for the heck of it. I'll just decribe the photos... 1) Of course the bulb holder wouldn't line up for the Lunasea G4 6 LED Warm White bulb. 2) Had to drill an extra hole...
  4. G

    Cargo shifting: Perko Nav light.

    All, Today I have a Perko Nav light (West Marine #123505) available for anyone who needs it. If you're the first to respond to me back channel at glynjudson@roadrunner.com and are willing to cover the postage, it's yours. On the face of it this well used light is no great prize but it also...
  5. wurzner

    Removing Nav Station-Sink-Stove area on 77 E-32-Any words of Advice??

    I'm considering removing the nave table area on my 77 E-32 to replace all my seacocks and valves, as well as evaluated my engine mounts and rear engine area. Has anyone done this and what am I in for? It's pretty tough servicing that area properly due to space limitations and I'm thinking...
  6. wurzner

    Removing Nav station-Stove Sink Area on 77

    I'm considering removing the nave table area on my 77 E-32 to replace all my seacocks and valves, as well as evaluated my engine mounts and rear engine area. Has anyone done this and what am I in for? It's pretty tough servicing that area properly due to space limitations and I'm thinking...
Top