pan

Here's a good one, can anyone help out here?!? Someone took a sawzall to the shower pan, not sure how they're supposed to look, but this one looks to have been cut apart?!? Will post pic.....

about a pint of engine oil in pan yesterday... Checked oil and it was a little over full. Looked at log and yes one of my Sea Scouts added a Qt last week. could not find drips or leaks until started and then our mechanic says from the oil switch. On line I found a note about the relief valve...

Greetings, My 1981 E 28+ has standing water in the fiberglass pan under the engine. I am guessing it is coming in from the shaft gland. Shouldn't this water drain down into the bilge? Even when I turn on the electric bilge pump the water remains in the pan under the engine. I wonder if...

Quick Question: For the first time I was cleaning the knotmeter wheel and as I removed it from the thru hull some water entered into the hull (the knotmeter wheel is below the v berth. ) I put the knotmeter back in with no problem and checked the bildge for water but there was none. I assumed...

The floor of the anchor locker pan on my E35-3 flexes whenever I crank on the manual windlass that I have installed inside the anchor locker. I've been wanting to reinforce it as well as rebed it, since I have some leaks there. I also wanted access to the underside of the bow pulpit and bow...

I am replacing the cabinets in the head of my 35-2, and, upon removal of old cabinets, noticed that the drain pan in the floor of the head does not lay flush against the hull...there is a running gap of 1.5in forward down to about .5 in aft. Is this gap there by design, or can I close fill the...

Lake Ontario sailor suffering severe withdrawal (boat ashore since October!)will be visiting Vancouver area April 12 - 25. Would really appreciate the opportunity to sail and meet fellow Ericson owner(s). E-mail keith.gloria.paremain@sympatico.ca Phone 613-253-0517 or when in Vancouver...

On and erIcson 38 I just found that the shower is leaking into the bow under the drawers. There is always water there. Has anyone undertaken this problem and if so are there any suggestions?