• Untitled Document

    Join us on September 27th, 7pm EDT

    for the CBEC Virtual Meeting

    All EYO members and followers are welcome to join the fun and get to know the people you've met online!

    See the link below for login credentials and join us!

    September Meeting Info

    (dismiss this notice by hitting 'X', upper right)

E35-2 scupper drain plumbing

steven

Sustaining Member
I'm again looking at re-directing the cockpit scuppers to drain out the stern instead of through the bilge.

Looks like there is (just) enough fall for a hose from the scupper(s) to exit though bottom of the stern overhang above the water line - aft and above the rudder.

I posted a thread on this in Jul 2019 and had some good replies. No need to re-post.
https://ericsonyachts.org/ie/threads/cockpit-drain-e35-2.16746/

Just wondering if anyone has done it or has further thoughts.

thanks

--Steve
 
Last edited:

steven

Sustaining Member
Thanks. Thats encouraging. Did you do the work yourself or engage a yard?
I'm a bit nervous about drilling through the hull on my own.
 

bigd14

Contributing Partner
Blogs Author
Thanks. Thats encouraging. Did you do the work yourself or engage a yard?
I'm a bit nervous about drilling through the hull on my own.
Yes, I did it myself. Take your time, measure six times, and make sure the hole saw size matches the thru hull closely. Practice on a piece of wood to make sure. I first drilled a pilot hole from the outside, then used a hole saw larger than the through-hull nut to cut the liner out from the inside using the pilot hole, then drilled the final hole through the hull from the outside to prevent tear out. I used Marelon through hulls, but didn't use backing blocks because of the liner. The hull was pretty solid in this area, but if doing it again I would put a backing block and a seacock on them. I could easily add a ball valve/seacock, but they are above the water line and have a low probability of getting damaged due to how far aft they are, so I haven't bothered.

I think it would be possible to do the work while in the water, but you would probably need to drill everything from the inside and you would definitely need a helper on a dinghy or dock or something, and hope that no waves happen during the critical time!
 
Top