1982

  1. J

    1982 Ericson 30 PLus FOR SALE

    IF you are looking for an E30 Plus please contact me at jamie@sealakeyachts.com. I own one and will be putting it up for sale. Has A 5416 Diesel 16HP fresh water cooled engine , wheel steering, 13.5 Kw Roof top AC Unit. two mainsails in above average condition, two roller furling Genoas, Storm...
  2. C

    Stanchion location on a 1982 38

    I own a hurricane trashed 38, 1982 vintage. What a project. The stanchions are gone and I removed the hull to deck joint and laminated the hull to the deck inside and out. as such the reinforcement points for the stanchion bases are obscured by the laminates. I am kinda looking for some pictures...
  3. Dferr

    1982 E-38 rudder grease fittings and leak

    While in the process of replacing my hot water heater, I was poking around and found two grease fittings on the the rudder tower. One up top, and one down low. The lower fitting was very badly rusted, and as I tried to remove it, of course it broke. I'm not planning on dropping the...
  4. J

    1982 ERICSON 33 Racer/Cruiser - Annapolis, MD

    Ericson 33 - FRANTIC (53043) is a Coast Guard documented, Ron Holland designed racer/cruiser built in 1982, Hull #4. In her last race she was 3rd in the 2006 Annapolis to Miles River Race. (PHRF B) She carries a fractional rig with rod rigging, nine winches, including self tailing primaries...
  5. Dferr

    1982 E-38 Questions, See photos.

    A few weeks back, I posted about the rusted coupling. Now I know why it's so rusted. The stuffing box is practically right up against it. there is no shaft exposed. Is this normal on all E-38s? How would one change the packing if need be? I clearly will have to cut this coupling off. Maybe I can...
  6. Dferr

    E-38 Stuffing box 1982

    Does anyone know what size packing goes in the stuffing box? The Boat is a 1982 E-38. Also, the coupling is so badly rusted I can't identify any of the bolts. It's pretty bad! This is going to be a real bear to replace. Maybe I'll just do what I did to my first boat. Cut the shaft, and start...
Top