Working through a full electrical refit on my Ericson 34-2 (PALOMA)
Planning a lithium + bus bar setup and trying to avoid the usual wiring chaos.
Curious how others here are handling:
• Solar + alternator charging together
• Bus bar layouts vs direct battery wiring
Any setups or lessons...
Refit Log #2 – Initial Look & Getting Oriented
Still in the early stages of getting familiar with the boat and starting to go through everything.
So far, I’ve mainly been taking a general look at the condition and layout before diving deeper into individual systems.
Overall impressions:
•...
Hello all,
I have been tasked with finding a new owner for Silverleaf, a 1989 Ericson 34-2 in need of a major refit. She is a beautiful and solid vessel on the outside, but unfortunately the interior needs to be replace--well, the floorboards, some trim, and one bulkhead at least. My wife and I...
Hi everyone,
Me and some friends are currently working on refitting an old Ericson sailboat, but we've hit many problems and would really appreciate some help and advice from the community.
1. We can’t identify the exact boat model and year
Unfortunately, there’s no plate or serial number...
I was aiming to make Hawaii this summer on the Singlehanded TransPac, but project delays and biting off more than I could proverbially chew are a couple of the culprits which have delayed my "start" until next summer. Here's a video ;)
Back in 1992, the second owner of an E38 hauled the boat for a total refit. The boat was partially disassembly (removal of mast, rigging and most bolt on exterior hardware). There was a complete stripping of bottom gelcoat (due to blisters) followed by re-fairing which include 2 layers of...
Just wanted to show the results of my work over the last 2.5yrs. It started with a bottom job, and I got a little carried away. Ended up completing the following:
1) Repaired cracks and gouges, epoxy filled holes for mounting hardware, and painted hull and deck & binnacle with Interlux...
The refit (storm damage repair, keel rebedding and Awlgripping) has launched on a positive note:
From the yard:
Hi Geoff,
Helmut has separated the hull from the keel and inspected the keel bolts, Helmut reports that the condition of the keel bolts is good, very little corrosion is evident...
I have a 1974 E27 with a Palmer P 60 gasoline engine. This was based on the IH60 engine seen in the Cub tractors. It is currently raw water cooled. I would like to add a radiator. I can purchase a new radiator for the IH Cub tractor. It would seem that all I would need to do is connect the...
I just had my 84 30+ painted , engine rebuilt, mast re done, re locate batteries, toss original ac and dc panels and replace with Blue seas systems, new charger, new bilge pump, replace hanging locker with 3 drop down shelves and I did it myself and learned a lot! Install dickenson newport...
i have just recently bought a 1973 e-27 that has been neglected for quite some time. I am not to sure what to check for on this boat to make sure that it is ready for sailing. I got a good deal on the boat because none of the cleats were backed by anything. Therefore one of these cleats were...