w or

I've owned Surveyor for two years and have kept her at HandyBoat, Falmouth Maine. Very good boat is a six out of 10 in condition. Tiller steering, 2007 Honda 9.9 . Has all the usual gear associated with the year. Cushions should be recovered but it's cosmetic. Solid boat, hull near perfect. A...

I'm looking to replace my old and non-functional gimbaled Kenyon with a new non-pressurized Cookmate 4200. From what I can tell from the measurements, I sounds like the recessed cookmate will drop right in to the gimbal that was used for the 209. But I'd like to be sure before I bought it...

We have a very clean 1979 Ericson 25+ deep keel model for sale at Marina Del Rey in Los Angles CA. We have reduced the price to $4,250! It has a 9.9 hp Mariner longshaft that has electric start and alternator. The Boat has a good + mainsail with boom vang and two reef points. The 110% Jib...

Selling our beautiful 1986 Ericson 32 along with our large custom built home on a well protected canal off Choctawhatchee Bay in the Florida panhandle. 126' of waterfront with dock plus boat lift for motorboat. See attached photos. Asking $795,000 for the package and will sell separately...

I have an Ericson-25 that I'd like to sell or otherwise... It's got a full keel (needing 3'10" of water to float), a tall rig, usable (but not new) sails and steps on the mast. The main and jib mounted on the boat work well though the starboard winch is seized and there's something wrong...

I'm considering buying a Ericson 30. The boat has a trasom mounted rudder, Keel stepped mast, and very beefy chain plates. In general, it looks much sturdier than most E 30's and 32's I've seen. In fact, it looks like it could take on blue water with few worries. I see few references to this...

I have a Perkins 4-108 Diesel motor out of an Ericson 46 for sale. It is a running take out. It ran fine, but needs the heat exchanger rebuilt. It also needs a starter rebuilt. The Velvet drive needs a need oil cooler and I cracked the bell housing when I removed it. It can be rewelded...

OK, I just bought a 1973 32-2 with an Atomic 4 that was rebuilt in 2000. Also new sails then. I am new to Great Lakes sailing and have been spoiled by East Coast sailing with inlets every 15 to 20 miles. Not so on lake Superior. What kind of range can I expect to have with the Atomic 4...