I have been spec-ing out the size and type of components for converting our ice box. I have measured our existing box several times and I calculate it to be (about) 3.0 cu. feet of interior.
I do not know why, but this just seems like "too small" of a number. The tape doesn't lie, though, so it appears that a Frigoboat Model 130F evaporator will do the job. This model is next to their smallest, and rated for a max. capacity of 6 cu.ft. "with good insulation."
Current plan is to install the Frigoboat "keelcooler" option when the boat is hauled for a bottom job this March. I have been advised to go with the version with zincs, as we have no bonding in this boat.
Compressor will be the K50-SSC model with Danfoss BD50 compressor. These use a "smart speed control" and a thermostat. At least that's how I understand it. Parts cost is said to run about $1200., give or take. I will have the yard install the keel cooler and I will do the rest of the installation.
There is room to put all the components under the sink, within a few feet of the side of the icebox.
Anyone with experience with this set-up or similar is invited to comment!

The boat is an '88 Olson 34. We have previously insulated the top and lid, the only parts not insulated by Ericson. We now get about 5 days out of 40# of block ice.
In case anyone wonders... block ice is getting harder to souce every season, after we leave our dock. All we find (everywhere! nowadays) is bags of cube ice.

Besides, I am ready for a change to Modern Times....
Advice anyone? Consent? Derision?
Thanks,
Loren in Portland, OR
I do not know why, but this just seems like "too small" of a number. The tape doesn't lie, though, so it appears that a Frigoboat Model 130F evaporator will do the job. This model is next to their smallest, and rated for a max. capacity of 6 cu.ft. "with good insulation."
Current plan is to install the Frigoboat "keelcooler" option when the boat is hauled for a bottom job this March. I have been advised to go with the version with zincs, as we have no bonding in this boat.
Compressor will be the K50-SSC model with Danfoss BD50 compressor. These use a "smart speed control" and a thermostat. At least that's how I understand it. Parts cost is said to run about $1200., give or take. I will have the yard install the keel cooler and I will do the rest of the installation.
There is room to put all the components under the sink, within a few feet of the side of the icebox.
Anyone with experience with this set-up or similar is invited to comment!
The boat is an '88 Olson 34. We have previously insulated the top and lid, the only parts not insulated by Ericson. We now get about 5 days out of 40# of block ice.
In case anyone wonders... block ice is getting harder to souce every season, after we leave our dock. All we find (everywhere! nowadays) is bags of cube ice.
Besides, I am ready for a change to Modern Times....
Advice anyone? Consent? Derision?

Thanks,
Loren in Portland, OR
Last edited: