Universal 5416 Starter Removal/Replacement
I have an '81 30+ with a universal 5416 and am in the process of replacing the starter. For anyone that's done this, is there any trick you've used to remove and get the starter in there? The access is tight and I can't come up with any sort of angle that would allow me to get the old one out. Hoping I don't need to disconnect the coolant hose and fitting at the bottom of the engine near there. Getting access to the bolts was no problem, but trying to angle that thing out... good grief..
If you have this same motor and have removed your starter - how did you do it? Do you recall how it was mounted? On my motor, the top of the starter is mounted on a stud with a nut, and the bottom mount is a bolt. If that stud wasn't there, I think the housing would clear easily enough in the enclosed space.
I have an '81 30+ with a universal 5416 and am in the process of replacing the starter. For anyone that's done this, is there any trick you've used to remove and get the starter in there? The access is tight and I can't come up with any sort of angle that would allow me to get the old one out. Hoping I don't need to disconnect the coolant hose and fitting at the bottom of the engine near there. Getting access to the bolts was no problem, but trying to angle that thing out... good grief..
If you have this same motor and have removed your starter - how did you do it? Do you recall how it was mounted? On my motor, the top of the starter is mounted on a stud with a nut, and the bottom mount is a bolt. If that stud wasn't there, I think the housing would clear easily enough in the enclosed space.
Last edited: