• Untitled Document

    The 2024-2025 Fund Raising Season has Opened!

    EricsonYachts.org has opened the season for raising funds to support the expenses of the site. If you would like to participate, please see the link below for additional information.

    Thanks so much for your continued support of EricsonYachts.org!

    2024-2025 Fund Raising Info

cracks

  1. L

    E27 rudder cracks

    My 1973 E27 is a project. I have a couple of cracks in the rudder and I'm wondering whether it would be a big mistake to put it in the water this weekend and wait until fall to make the needed repairs.
  2. A

    Horizontal cracks in rudder.

    Hello all, during haul-out I noticed two horizontal cracks on one side of the rudder of my E27. I sanded the cracks only to discover that they are gel coat deep they don't go through the fiberglass layer. This weekend I epoxyed them with the same west system 105/205/406 epoxy that I was using to...
  3. mherrcat

    Cracks in swage fittings

    A survey done by the previous owner noted cracks in the cap shroud swage fittings. The insurance company wants me to replace those shrouds before they will insure the boat for navigation. I think the surveyor indicated the wrong shrouds. The intermediate shrouds have cracks, but I can't find any...
  4. G

    rudder-spider cracks

    I have a '76 29' Erickson. In the last few years I have noticed some spider-cracks in the rudder. I assume this may mean that I have some moisture in the rudder. There has been no rudder damage in the 6 years I have owned the boat. My course of attack is to drill a small hole up from the...
  5. K

    E30+ Cracked Support Stucture for Motor mounts and rudder cracks

    We were looking at a 1980 E30+ that is for sale on the great lakes and noted that the composite support frame for the deisel motor mounts is cracked . The forward side to side support frame is cracked open along its forward edge over its entire length. The port side forward /aft support...
  6. S

    Rudder cracks anyone?

    Here is another issue with my E27, My rudder has developed cracks on the gelcoat, I don't think there is any water sipping on the inside but I would like to fill the cracks before I paint it and launch it for the season. I was wondering if anyone has any experience fixing these cracks in the...
  7. Luffin it

    vertical cracks on mast at spreader bar monuts

    As I was replacing my spreader boots on our E-27 with Wheel, I notices a small crack in the mast on the aft edge of the mounting plate for the spreader. It looks as if it an inch an quarter long running vertical. What is the fix for this problem? Do you first pre-drill a small hole at each...
  8. G

    M25 alternator mount cracks gear case cover

    I am in the process of installing a Balmar alternator on my 1985 Universal M25 engine. In the course of researching the mounting (on the Catalina site) I came across dire warnings about how the pre-1988 method of mounting to the bracket, which is attached to the aluminum gear case, will...
Top