Guest viewing is limited
- You have a limited number of page views remaining
- 11 guest views remaining
- Register now to remove this limitation
Interior Refit
- Thread starter Chschaus
- Start date
gareth harris
Sustaining Member
On Freyja the side panelling was screwed on to two pieces of wood each side which were contoured to the hull and fixed to it with epoxy.
That may or may not be relevant to your newer boat.
Gareth
Freyja E35 #241 1972
That may or may not be relevant to your newer boat.
Gareth
Freyja E35 #241 1972
Can you expand on what panels you are replacing? Cabin sides? Hull ceilings? Other? Can you attach a photo or two?
I ended up using thickened epoxy:
ericsonyachts.org
The original paneling was attached using thickened resin and it stayed on for 30+ years (frustratingly good when it came time to remove it), so I figured I'd do the same.
Construction adhesive would also be a good choice. 3M 4200 would probably work, but it's more of a sealant with adhesive properties. You'd be paying for a feature that's not needed in this application.
Atach Cabin Side Plywood
(Pictures are of the template and before the recore) Now that the recore on the port side is done, its time to install the new piece of teak plywood. I've thought about vacuum bagging it, but the aft section would be next to impossible to create a seal and I don't think I could line up the...
The original paneling was attached using thickened resin and it stayed on for 30+ years (frustratingly good when it came time to remove it), so I figured I'd do the same.
Construction adhesive would also be a good choice. 3M 4200 would probably work, but it's more of a sealant with adhesive properties. You'd be paying for a feature that's not needed in this application.
