hinge

Hello, Has anyone added a mast hinge to an Ericson 23 Mark II? I was looking at the DwyerDH2150. Would this be the correct size? http://www.dwyermast.com/items.asp?cat1ID=40&cat1Name=Hardware&familyID=18&familyName=Hinges Thanks, Fred Nelson

My winter project has been building companionway doors. I'm to the point of mounting the hinges for them and was looking for insight/advice. The attached picture was taken during the first pass fitting and since then I have mounted the teak weather strip pieces in front and back that cover the...

I stepped my mast for the first time with the tabernacle or hinge step plate that I built from the drawings shown in the E27 and partially in the E29 manual (this is stated for the 27 and 29 on the drawing). I should have sold tickets at the club for watching, there was a large crowd there to...

I plan to install a rigid vang on my E27, but expect interference when opening the middle hatch with hinges aft. Anyone with tips, tricks or traps for reversing the hinge to have it open the other way? I have the original style hatches and have started to make the wood block that will hold the...

One of the findings in my recent rig survey was that the vertical hinge in the gooseneck toggle fitting was wearing and it was recommended that I install a sacrificial washer to reduce that wear. When I went to do the job I discovered that the 1/2" pin that had to be pulled to do this, was...

New replacement hinges for a Lewmar Rollstop (style name) hatch. The Rollstop hatches were made from ’86 to ’92. Fits the size 50 (444 x 574 mm), 60 (574x574 mm) and size 70 (694 x 694 mm) per the Lewmar web site http://www.lewmar.com/webspares/index.asp Part number is 19782200 and lists for...

My boat (1987) has Lewmar ports which open at predetermined positions. Several are wearing to the point that the detent stop don't want to hold. Is there a way to replace or repair the hinges? I emailed Lewmar but no answer so far.