position

The PO of my E35-2 moved the Main sheet traveller from the bridge deck just in front of the pedestal, to the forward end of the cockpit.<O:p</O:p I had originally thought of returning it to its right full place, giving unobstructed access to the cabin. But, as I intend to use the boat for...

I was breaking ice scrapers this weekend on the frozen snow that cover our boat before I was able to assemble the winter cover. As I was getting warm again sitting in my truck, I noticed the hull deflected from the support on the forward port side. Is there a specific location for the a pads...

As the engine mounts on my 1972 E35-2 had rusted away, and I need to fit a new engine anyway. To give us a bit more room I have decided to re-locate the engine under the companionway steps. Has anyone else out there done it? All the brochures and plans I have found so far have shown the engine...

I have a new rudder position sensor that came with my new S1 wheel pilot. I already have a sensor so I am selling this one. It plugs directly into the seatalk interface on any Autohelm or Raymarine AP that support Seatalk. Or add a display to use it stand alone. Asking $175 + shipping.

We own a 1988 34. We have substantial wheel pull to port, mostly while motoring, but slight while glide/sailing. Boat is out of the water now, and I have noticed that the aft end of the prop shaft is about 3/4" to starboard of center/line of keel and small rudder skeg. The bronze skeg that...

I finally have the mechanical installation of my RPS complete. I removed the quadrant. This made the installation much easier. In the first photo you see the RPS installed on the bottom of the cockpit sole. The center of the RPS is in line with the center of the rudder post. The arm is...

Has anyone installed an RPS on their 35-3? I am getting ready to do mine(Raymarine) and would appreciate any info and/or photos.

Among this year's upgrades was replacing the very old Autohelm ST4000 wheel pilot on our E33 with the current offering from Raymarine. I have gotten a ways into the installation and run into the typical minor problems and questions involved in any boat project and am continuing to work through...

I'm in the process of installing a Raymarine S1 (the ST4000 replacement) autopilot. I'm looking for advice, pictures and thoughts on how to best install the rudder position sensor. I searched and found some info, but thought I'd see if anyone had some more info. As always thanks for your help!